a. Remove the nut and terminal insulator
b. (40 A type)
Remove three bolts and end cover
(45 A Type)
Remove three bolts and end cover
2. Remove brush holder and IC Regulator
remove the five screws, brush holder and IC regulator
a. Remove the four screws
b. using pliers, straighten the stator lead wire
c. remove the rectifier holder
Remove the four screws, rectifier holder and rubber insulator
4. Remove Pulley
a. Hold SST "A" with a torque wrench and tighten SST "B" Clockwise to the specified torque.
SST 09820-63010
Torque : 400 kg-cm ( 29 ft-lb, 39 N.m)
b. Check that SST "A" secured to the rotor shaft
c. As shown in the figure, mount SST "C" in a vise and then install the alternator to SST "C".
d. To loosen the pulley nut, turn SST "A" in the direction shown inte figure
COUTION : To prevent damageto the rotor shaft, do not loosen the pulley nut more than one-halfof a turn
e. Remove the alternator from SST "C".
f. Turn SST "B" and remove SST "A". Remove the pulley nut and pulley.
